| Poster |
Message |
 Cristo30
|
 Chevrolet Transpordi automaatne uste lukustus.
Tere.Kas keegi teab missuguste nuppude vajutustega saab uuesti seadistada kohalt liikudes automaatse uste lukustuse.See lukustus kadus kuidagi iseenessest ära.Autoks on transsport 2001a,138 kw ja 3,4L.
Tänud juba ette ära.
____________________________
CK |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
16.10.2011 at 07:24 |
|
antennimees
 |
 Chevrolet Transpordi automaatne uste lukustus.
USA variandil käib nii programeerimine, euro variandil võib teisiti olla aga seda õpetust mul pole.
PROGRAMMING
ENTER FEATURE CUSTOMIZATION MODE
Turn Instrument Panel (IP) dimmer switch fully to right position, then slightly left. Turn ignition switch to OFF position. Remove BCM PRGRM (10-amp) fuse from instrument panel fuse block. Turn ignition switch to ACC position. BCM first identifies what type of Body Control Module (BCM) is installed on vehicle by sounding instrument panel auxiliary chime 2, 3 or 4 times. Ensure BCM type currently installed is correct for equipment and features of vehicle. See BODY CONTROL MODULE IDENTIFICATION under SELF-DIAGNOSTIC SYSTEM. After BCM type is identified, BCM will enter into feature customization mode. Feature customization settings can now be programmed. See appropriate procedure(s) under FEATURE CUSTOMIZATION MODES .
FEATURE CUSTOMIZATION MODES
Automatic Door Lock Modes
Enter feature customization mode. See ENTER FEATURE CUSTOMIZATION MODE . Press and release any power door lock switch. Count number of chimes to determine current mode (1-4). See AUTOMATIC DOOR LOCK OPERATION MODES table.
AUTOMATIC DOOR LOCK OPERATION MODES
Mode Shift Out Of Park Lock Ignition Off Unlock Shift Into Park Unlock
1........Disabled.....................Disabled.................Disabled
2........Enabled......................Disabled.................Disabled
3........Enabled......................Enabled.................Disabled
4........Enabled......................Disabled.................Enabled
To change mode, press and release any power door lock switch to OFF position to advance to next mode until desired mode is reached. Chime will sound number of times equivalent to mode. Chime indicator sequence will repeat after chime sounds for mode 4. Mode 3 is default mode.
To exit and save current feature customization mode settings, turn ignition switch to OFF position. Reinstall BCM PRGRM (10-amp) fuse. If unable to change locking control modes, diagnose power door lock fault. See DOORS DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
____________________________
'05 Chevrolet SSR & '03 Cadillac Escalade EXT |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
16.10.2011 at 07:53 |
|
|
