| Poster |
Message |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
 R.Ott
 |
 Vaakummõõtja karpa regulliks?
Oleks vaja karpa paika panna:
"The two screws in the front is idle mixture settings only. It will NOT lean out or richen the carb during norm driving. Also it only controlls amount of AIR not fuel
It only helps you to get a good/better idle. Best way to tune is by a vac gauge reading. Forget which way is lean or rich cause that don't matter. Hook a vac gauge to full intake vac, turn one screw in slowly till engine tries to die, then as your turning screw outward, look at vac gauge. Turn screw untill you get the hiughest reading you can on gauge. It will get to a point where vac will do down or not change at all.Now do the same thing to the other screw as your watching the vac gauge
Source(s):
Performance/Race engine builder, 12+ years"
Tegin foorumis otsingut ja sõelale jäi, et "BMW seieriga kulumõõtja on tegelikult sisselaske vaakumi mõõtja"
Või on kellegil paremaid ideid?
Edit.
Hetkel on suurimaks probleemiks liiga rikas segu tühikäigul - tahmab/suitseb tühikäigul niiet foori all seisma jäädes tapab tagapool seisjad ära...
____________________________
92' Chrysler LeBaron LX Convertible
94&95' Pontiac TransSport 3800 +doonorid
88' Chevrolet Camaro Iroc-Z convertible- 20th Anniversary Edition |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
29.04.2010 at 22:42 |
1 edit. Last edited 29.04.2010 at 22:46 by R.Ott
|
79capri
|
Vaakummõõtja karpa regulliks?
quote:
R.Ott: Oleks vaja karpa paika panna:
"The two screws in the front is idle mixture settings only.
Edit.
Hetkel on suurimaks probleemiks liiga rikas segu tühikäigul - tahmab/suitseb tühikäigul niiet foori all seisma jäädes tapab tagapool seisjad ära...
Need 2 boltid rigullivad air / fuel ratio tühikäigul.
PS. vaakumi mõõtja mul ka olemas. |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
30.04.2010 at 09:39 |
|
Stang-R
|
Vaakummõõtja karpa regulliks?
abiks ikka:
http://www.earlycuda.org/tech/vacuum2.htm
http://www.classictruckshop.com/clubs/earlyburbs/projects/vac/uum.htm
http://www.chevyhiperformance.com/howto/45638/index.html
____________________________
Mustang 68 HT |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
30.04.2010 at 09:56 |
|
