Warning: Undefined variable $HTTP_SERVER_VARS in /data01/virt688/domeenid/www.tqhq.ee/test/include/packer.php on line 14
Warning: Trying to access array offset on null in /data01/virt688/domeenid/www.tqhq.ee/test/include/packer.php on line 14
Warning: Undefined array key "page" in /data01/virt688/domeenid/www.tqhq.ee/test/forum/viewtopic.php on line 7
Warning: Undefined array key "spid" in /data01/virt688/domeenid/www.tqhq.ee/test/forum/viewtopic.php on line 8
Warning: Undefined array key "nfkasut" in /data01/virt688/domeenid/www.tqhq.ee/test/forum/viewtopic.php on line 25
Warning: Undefined array key "nfsalas" in /data01/virt688/domeenid/www.tqhq.ee/test/forum/viewtopic.php on line 26 tqhq.ee foorum - Jyrki? Warning: Undefined array key "nfkasut" in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 203
Jyrki?Jyrki, onko Sulla mitään tietoja, missä on mahdollista tasapainottaa kampiakselia (Helsingin lähellä, hintaluokka?)? Meillä Virossa ei ole yhtäkään toimivaa konetta. Kampiakseli on V8 400 cid SBC.
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
26.09.2001 at 14:21
Jyrki?Personaalsete pöördumiste korral on efektiivsem ja kiirem variant saata mail. Selleks tuleb klikata vastavale iconile kasutajanime all mõne postituse juures kus vastav isik on sõna võtnud.
[Edited by peep on 26.09.2001 at 16:03 GMT]
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
26.09.2001 at 16:03
Jyrki?There are two places near Helsinki; the other is only two houses down from my garage. The last time I balanced the crank there it cost around 1000 FIM. In the case of 400 crank you have to include the flex plate and the harmonic damper with the crank since it's externally balanced. The pistons & rods should also be balanced for best results; pistons are usuall close enough if they are decent quality but the rods amy be way off. I have seen as much as 70 gram differences inside the same stock engine, but of course that was a Mopar Balancing the rods is pretty expensive since you have to balance the small & big ends separately and need some equipment to do that properly. But still it's a job that can be done yourself if you have an accurate weight scale. Aftermarket rods are usually close enough so they don't have to be balanced. Hope this helps
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
28.09.2001 at 08:18
Balancing the rods is pretty expensive since you have to balance the small & big ends separately and need some equipment to do that properly. But still it's a job that can be done yourself if you have an accurate weight scale. Aftermarket rods are usually close enough so they don't have to be balanced. Hope this helps 