| Poster |
Message |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
 juweel
|
 Delco cd/raadio
Sai leitud Delco Loc II cd / raadio .
Kuna pole kindel kas töötab ja pole lukus paluks abi selle proovimisel.
Originaalis paigaldatud järgnevatele:
Buick - 1989-1994*
Cadillac - 1989-1994*
Chevrolet - 1989*-2002*
GMC - 1989-2002*
Oldsmobile - 1989-1994*
Pontiac - 1989-2002*
Saturn - 1989-1999*
Pilt orig, pistikust GM Replacement radio Plug: 20-pin
http://replacementradios.com/popup_image.php?pID=65
http://www.iroczone.com/2009/10/1988-to-1992-camarofirebird/
5168337 |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
02.10.2010 at 11:39 |
1 edit. Last edited 02.10.2010 at 16:07 by juweel
|
Vanaisa
  Moderator |
Delco cd/raadio
Ilma koodita ise vast midagi teha ei saa:
How to unlock a THEFTLOCK or DELCO-LOC II audio system
DELCO-LOC II
Disabling the anti-theft feature
1.) press the sterio's PREV and FWD buttons at the same time for five seconds with the ignition on and the radio power off. The display will show SEC, indicating the unit is in the secure mode (anti-theft feature enabled)
2.) Press the set button. The display will show "000"
3.) Press the SEEK button to make the first number appear.
4.) Rotate the TUNE knob right or left until the second and third digit of your code appear. The numbers will be displayed as entered.
5.) Press the band knob. "000" will be displayed
6.) Press the SEEK button to make the fourth number appear.
7.) Rotate the lower knob until the fifth and sixth digits of the code are displayed.
8.) Press the lower BAND knob. If the display shows "_ _," you have sucessfully disabled the anti-theft feature. If SEC is displayed the code you entered was incorrect and the anti-theft feature is still enabled.
Unlocking DELCO-LOC II after a power loss
when power is restored to the stereo, the stereo won't turn on and LOC will appear on the display. Enter your ID code as follows;
1.) Turn the ignition switch to ON, but leave the stereo off.
2.) Press the set button. The display will show "000"
3.) Press the SEEK button to make the first number appear.
4.) Rotate the TUNE knob right or left until the second and third digit of your code appear. The numbers will be displayed as entered.
5.) Press the band knob. "000" will be displayed
6.) Press the SEEK button to make the fourth number appear.
7.) Rotate the lower knob until the fifth and sixth digits of the code are displayed.
8.) Press the lower BAND knob. If the display shows SEC appears, the numbers you entered were correct and the stereo will work. If LOC is displayed the code you entered was incorrect and the stereo will be inoperative.
THEFTLOCK
Disabling the anti-theft feature
1.) Press the stereo's 1 and 4 buttons at the same time for five seconds with the ignition on and the radio power off. The display will show SEC, indicating the unit is in secure mode (anti-theft feature is still enabled)
2.) Press the MIN button. the display will show "000."
3.) Press the MIN button to make the last two numbers appear.
4.) Press HR to display the first one or two numbers of you code. The numbers will be displayed as entered.
5.) Press AM/FM. The display shows "_ _," you have successfully disabled the anti-theft feature. If SEC is displayed, the code you entered was incorrect and the anti-theft feature is still enabled.
Unlocking the stereo after a power loss
when power is restored to the stereo, the stereo won't turn on and LOC will appear on the display. Enter your ID code as follows;
1.) Turn the ignition switch to ON, but leave the stereo off.
2.) Press the MIN button. the display will show "000."
3.) Press the HR button to make the last two numbers appear.
4.) Press the HR button until the first one or two numbers appear
5.) Press AM/FM. SEC shoulld appear, indicating the stereo is unlocked. If LOC appears, the numbers you have entered were not clorrect and the stereo is still inoperative. |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
02.10.2010 at 11:49 |
|
cce
|
Delco cd/raadio
mul on siuke ots kaablitega olemas kui proovida tahad,ja ühes
või kahes autos ka. |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
02.10.2010 at 20:37 |
|
rescue
|
Delco cd/raadio
sellise vahetüki saad kah tellida ISO-le, ise tellisin inglismaalt ja ca 100.- läks vist |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
03.10.2010 at 18:15 |
|
Redneck
|
Delco cd/raadio
Ei hakka uut teemat tegema, aga oleks kah tarvis kas siis adapterit ISO'lt või siis samasugust pistikut ennast.
Oskab keegi soovitada kust võiks saada.
Tlnas Oomipood ja Noor Tehnik igatahes ei aita GM'i poole pealt. |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
20.04.2011 at 11:51 |
|
rescue
|
Delco cd/raadio
quote:
Redneck: Ei hakka uut teemat tegema, aga oleks kah tarvis kas siis adapterit ISO'lt või siis samasugust pistikut ennast.
Oskab keegi soovitada kust võiks saada.
Tlnas Oomipood ja Noor Tehnik igatahes ei aita GM'i poole pealt.
http://cgi.ebay.co.uk/PC2-82-4-Chevrolet-Blazer-Camaro-Corvette-ISO-Lead-GM-/160341609293?pt=UK_Cars_Parts_Vehicles_Terminals_Cabling_ET&hash=item25551acb4d
See pole see?
|
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
20.04.2011 at 13:55 |
|
Redneck
|
Delco cd/raadio
quote:
rescue:
http://cgi.ebay.co.uk/PC2-82-4-Chevrolet-Blazer-Camaro-Corvette-ISO-Lead-GM-/160341609293?pt=UK_Cars_Parts_Vehicles_Terminals_Cabling_ET&hash=item25551acb4d
See pole see?
Minu puhul on häda selles, et mul on see pistik, mis maki tahab käib veidi eelnevalt kellegi poolt peeti keeratud.
Ehk on kaablid on väga pistiku äärest ära lõigatud ja hiljem tehtud mingi tinutustöö... paraku aga need ühendused pole teabmis kindlad ja mõni ühendus ongi juba ka ära murdunud.
Olekski tarvis kas siis uut pistikut (papa) või siis adapterit ISO(mama)-vajaolev(papa)
Antud lingil see "mama" tundub maki omaga üsna sarnane olema küll. |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
20.04.2011 at 14:44 |
|
antennimees
|
Delco cd/raadio
GM raadio taha käivat pistikut võid minu käest küsida mul vähemalt 10cm juhtmejuppidega see olemas. Helista ette ja lepi kokku.
____________________________
'05 Chevrolet SSR & '03 Cadillac Escalade EXT |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
20.04.2011 at 19:21 |
|
Redneck
|
Delco cd/raadio
quote:
antennimees: GM raadio taha käivat pistikut võid minu käest küsida mul vähemalt 10cm juhtmejuppidega see olemas. Helista ette ja lepi kokku.
Ohh väga viis! Homme päeval helistan! |
Warning: Undefined variable $offset2 in /data01/virt688/domeenid/www.tqhq.ee/test/forum/func.php on line 306
20.04.2011 at 19:31 |
|
